Additive manufacturing (AM) is a technology that arose from rapid prototyping. This technology (AM) is revolutionising our existing way of manufacturing. AM is part of the fourth industrial revolution that we are currently experiencing in the areas cyber-physical systems. This Society of Plastic Engineers technical seminar organised at RMIT University is aimed to cover a wide range of topics from both global and Australian perspectives and how additive manufacturing is changing the way industries will operate in near and distant future.
Our speakers will share their knowledge on how this state-of-the-art technology would benefit various stakeholders in industries and the job opportunities this technology has the potential to create. The seminar is followed by a facility tour where the users can physically see how this cutting-edge technology has spearheaded into various industries including aerospace, automotive, biomedical, consumer, defence, manufacturing and textile industries.
Date/Time: Tuesday, 19th March 2019, 5:30 pm to 9:00 pm
Venue: Advanced Manufacturing Precinct (Building 55, Level 2)
58 Cardigan St, Carlton VIC 3001
(Corner of Queensberry and Cardigan streets)
The seminar program is as follows:
5.30 pm to 5:55 pm
Registration (Tea and coffee on arrival)
6:00 pm to 6:05 pm
Welcome
Dr Muthu Pannirselvam, Program Coordinator, SPE: A-NZ Section
6:05 pm to 6:10 pm
Introduction to Additive Manufacturing Precinct
Prof Milan Brandt, RMIT University
6.10 pm to 6.25 pm
Global Trends in Additive Manufacturing
Alex Kingsbury, Additive Economics
6.25 pm to 6:40 pm
The Changing face of Manufacturing in Australia
John Croft, AMTIL
6:40 pm to 6:55 pm
Simulation in additive manufacturing for better productivity and higher yield
Dr Dayalan Gunasegaram, CSIRO
6:55 pm to 7:10 pm
White paper - bio-manufacturing
Dr Ravi Shukla, RMIT University
7:10 pm to 7:25 pm
Commercial opportunities for Additive manufacturing in Plastic industries
Prof Martin Leary, RMIT University
7:25 pm to 7:30 pm
Thank you
Prof Ivan Cole, ECP Director – Advanced Manufacturing and Fabrication
7:30 pm to 8:10 pm
Facility tour led by Prof Brandt and Prof Leary
8:10 to 9:00 pm
Networking session with finger food and drinks
For further information or questions contact Muthu Pannirselvam at muthu@rmit.edu.au or 0451 902 1
Comments